Drywall Repair

Drywall, also known as gypsum board, plasterboard, sheetrock and a lot of other names is a material used in constructing the walls of your home. As durable as drywall is, it will need to be repaired over time. Drywall is a material that is made from recycled paper and needs to be well maintained for it to last long. It is important to check out for any sign of damages so as to repair it immediately before it becomes too severe to be repaired. An alternative to repairing a drywall is replacing it and that is an extremely expensive option. There are several ways to repair your drywall and ensure that it has a long lifespan.

Drywall Dent Repair

Dents are the most common damages found on a drywall. Repairing it can be very easy if you follow the rules and guidelines. To repair the dents in drywall, you need to have a flat blade taping knife, sanding block, and sandpaper. The first step is to use a flat blade taping knife to apply a drywall joint compound to the dent. After about 24 hours when the compound is dry, sand the surface very lightly with a sand block and grit sandpaper. The sand block is used instead of your hand for a good result. After this has been done, if the compound appears shrunken, then you should repeat the process.

Replacing Loose Nails

The drywall of many homes are constructed using just nails instead of adhesives and drywall screws which is a preferred option but causes a lot of problems in the long run. The wood studs become dry or bends which places too much pressure on the drywall beyond the power of the nails. Eventually, the nails loosen, causing more problems for the home owner. The best thing to do is repair it immediately before the whole wall collapses. The process is very easy, all you have to do is remove the nails and the bent woods and replace them with new ones.

The Process of Repairing a Drywall

If the damages on your drywall are too severe for a quick repair, it is better to replace the whole wall. The process is not an easy one but with the right tips and guideline, it will be less stressful than it is. The first step is removing the damaged section of the drywall with a knife. Cut the drywall and stop at the studs that are outside the damaged area, continue cutting till the whole section is removed. The second step is to attach a new stud to the current stud to give the new drywall a more efficient pillar. The third step is attaching a new drywall to the place where the old one was cut out. Ensure that the drywall is placed at the center of a stud for it to be strong and durable. The last step is filling the gap between the old and new drywall with a joint compound that dries quickly.

FREE INSTANT QUOTE

ENTER YOUR INFO BELOW

14 + 11 =